The 12V Solar Pumping Kit for continuous use incorporates a Shurflo pump that works with a 12V power supply.
Characteristics of the 12V Solar Pumping Kit system for continuous use
The photovoltaic system provided in the attached file can generate 0.48 kWh per day in winter (3 hours of sunshine) and 1.12 kWh in summer (7 hours of sunshine).
The characteristics of the proposed system are the following:
Installed solar generation: 160 W
Daily production in winter: 0.48 kWh
Summer: daily production: 1.12 kWh
Annual average daily production: 0.80 kWh
Components of the Solar Pumping Kit 12V continuous use
1 x ERA Polycrystalline 160W 12V Solar Panel: a 25-year warranty provides high reliability for our photovoltaic systems. It can supply the solar system with about 500 Wh per day in winter and almost twice as much in summer. Includes 1 meter of cable for each pole (both positive and negative). Including the connection box at the rear of the solar module. This photovoltaic module comes with a pre-assembled frame made of anodized aluminum.
1 x ATERSA PM5 12V Water Pump Controller: Atersa’s PM5 water pump controller allows you to install a 12V water pump without a battery. Ideal for direct pumping systems and pressure groups where the water needs to be pumped or moved horizontally.
2 x Level Probe for ATERSA PM5 Controller: ATERSA’s PM5 Level Probe is available in 12V and 24V and is used to control water pumps that use directly through solar panels.
1 x Shurflo Pressure Pump 12V 2088-443-144 10 l/min: it can produce at 0 m depth, but at height 28 it has a flow rate of 7.9 l/min m. Introducing the Shurflo 2088 514 145 booster set. The pump runs on 12V DC and can pump 13.6 liters per minute at a maximum pressure of 2.8 bar. You want to open a pressure tap or heater, either gas or electric. This pressure group can be used for continuous use. This means that the integrated motor cannot heat up to dangerous temperatures for the pressure pump, so it can run 24 hours a day. Thanks to this engine, you can keep the pressure groups continuously connected and use them as continuous consumption pressure groups. Consult the product or the technical data sheet.
1 x Roll Unifilar Cable 6mm2 H1Z2Z2-K 10m red: special for electrical installations. Halogen-free flexible power cables for the most demanding industrial requirements.
1 x Roll Unifilar Cable 6mm2 H1Z2Z2-K 10m black: special for electrical installations. Halogen-free flexible power cables for the most demanding industrial requirements.
1 x WEIDMULLER PVStick Connectors – Most recommended if you don’t have crimping tools that can connect normal MC4 connectors. They are compatible with all connector models that come standard with solar panels and require no tools to connect to the cable.
