The VICTRON SmartSolar MPPT RS 450V 200A Regulator provides maximum performance in any panel. It incorporates internal Bluetooth.
Characteristics of the SmartSolar MPPT RS 450V 200A VICTRON Regulator
It is a solar charge controller with ultra-fast maximum PowerPoint tracking (MPPT). It operates at 58V with a photovoltaic input of up to 450VDC PV and an output of 200A. Its most common uses are in off-grid and grid-connected installations where maximum battery charging power is required.
It has multiple independent MPPT tracking inputs, allowing you to optimize your solar panel design for maximum performance in one location.
In addition, it has a screen that shows the parameters of the batteries and the controller. They can also be accessed via mobile phone or other Bluetooth device. Bluetooth is also used to configure the system and change Victron Connect parameters.
Its installation is very simple. Thanks to its high-frequency technology and new design, this SmartSolar MPPT RS 450V 200A VICTRON Regulator weighs 13.7 kg and has dimensions of 487 x 434 x 146 mm. It also features high efficiency, low idle power consumption and very quiet operation.
Another feature it incorporates is the VE Port. Can and VE. Direct that allows it to be connected to a GX device for remote system monitoring, data logging and firmware updates. With the VE. Can it is possible to connect up to 25 units together in parallel and synchronize the charging processes.
Below, you can see an example diagram of a system. In this case, the Smart Solar regulator is combined with a GX device, charging a 48V battery with two separate solar photovoltaic strings.
Technical data Regulator SmartSolar MPPT RS 450V 200A VICTRON
– Photovoltaic power limitation 11.5kW at 57.6V battery.
– Maximum voltage of the photovoltaic circuit: 450V. The open circuit voltage must not be 8 times higher than the battery float voltage.
– With forced ventilation. 96% efficiency.
– Own consumption of 15mA.
– Working temperature between -40 and +60ºC.
– IP21 protection. Maximum humidity without condensation 95%.
– Reverse polarity protection of PV panels, against short circuit in the output and temperature.
– VE compatible. Direct, VE. Can and Bluetooth for communications.
– Synchronized parallel operation of up to 25 units.
– 13.7Kg of weight and dimensions of 487 x 434 x 146 mm.
– Programmable relay, temperature sensor, digital input and insulation sensor.
– With digital screen to visualize in situ.
